Latest WACUP public preview for x86 & x64 is build #24960 (August 31st 2026) (x86 & x64 changelogs)
Latest restricted WACUP beta release is build #24960 (August 31st 2026) (x86 & x64 changelogs)

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Nukesforbreakfast

Pages: [1]
1
General Discussion / Re: WACUP 1.99.54.24960 crash
« on: September 01, 2026, 06:42:55 PM »
I'm using the x64 build. I tried switching from notsodirect to notsoyasapi and the behavior was the same. I did uninstall via the installer and selected remove profile info, but when I reinstalled a non-portable install it launched remembering the playlist + current song + current song time. I'll try again and see if I missed something, and I'll try a portable install to see if that changes behavior. Thanks!

2
General Discussion / WACUP 1.99.54.24960 crash
« on: August 31, 2026, 11:36:43 PM »
Hello,

I've inexplicably started experiencing WACUP crashes with the 1.99.54.24960 64-bit WACUP build. Any time I try to change songs, or the current song finishes and it tries to go to the next song in the playlist, it hangs and then closes. As far as I can tell, it is not saving any crash dumps because I see none linked under the Advanced -> Error Reporting. I tried using the ProcDump button in the UI as well as running `wacup.exe /procdump` in a CMD window, but it doesn't restart when clicking the button and wacup doesn't launch when trying to run from CMD.

I tried uninstalling and reinstalling, but it seemed to remember the playlist/song information when I started it back up after a new install, so the clean install instructions I found didn't clear everything out as I expected. Are there official clean install instructions somewhere I can follow to try and resolve this, or some other way of trying to capture a crash dump or other diagnostic info?

Thanks!

Pages: [1]