WACUP

General => Wishlist / Feature Requests => Topic started by: 956400 on November 28, 2018, 05:31:01 PM

Title: hotkey for cycling through output devices
Post by: 956400 on November 28, 2018, 05:31:01 PM

...with notification toast for each change?

six clicks to change soundcard is really too much :)

Title: Re: hotkey for cycling through output devices
Post by: hatecubed on November 29, 2018, 12:05:12 PM

I would love for this to be implemented, if possible! :)

Title: Re: hotkey for cycling through output devices
Post by: dro on November 29, 2018, 12:32:17 PM

See you talking about from within a specific output plug-in or changing the actual output plug-in? As the first which I suspect is what's wanted would need to be done by the indovidual output plug-in.

-dro

Title: Re: hotkey for cycling through output devices
Post by: 956400 on December 03, 2018, 05:32:05 PM

just a basic cycle through available directsound devices would be more than enough... a special choice of cyclable devices would be even more awesome (then a change notification wouldnt be needed) or even an alt+shft+1...5 for number of device. whatever is easiest really.
notification could be in the scrollable song title field/taskbar for example. no need for new interface elements.

Title: Re: hotkey for cycling through output devices
Post by: dro on December 03, 2018, 07:15:38 PM

Ok, so it was as I thought - it needs to be done by the output plug-in due to output device selection being specific to the output mode used. Not much I can really do with the DirectSound plug-in as I don't think there's an interface it exposes to live change things either (you'd be looking at best a hack that causes a restart to allow for the config used to be manipulated which defaults the point of what you're wanting).

-dro